Kipatikana Bidhaa Maarufu
ZX-GT2840S41
ZX-GT2840S41 ZX 5006M 238019 OMRON Barrier sensor 40mm 10μm Max. width 28mm PNP
$4,093.66USD
43 kwenye hisa
Vipimo Muhimu
Shikilia (Vipimo):Sample hold, peak hold, bottom hold, peak-to-peak hold, average hold, delay hold
Bidhaa (Vipimo):ZX-GIF11/-GIF11A
Nyingine (Vipimo):Measurement cycle setting, threshold setting, hysteresis setting, initialization, key lock
Nyenzo (Vipimo):Case: PBT (polybutylene terephthalate), cover: Polycarbonate
Taarifa za Msambazaji
OMRON
Bidhaa: 41472
Kwa kawaida husafirisha ndani ya siku 2-3 za kazi
Ubora Umeheshimiwa
Usafirishaji wa haraka
Msaada wa Kiufundi
Speci ya Kiufundi
| Kipengele | Thamani |
|---|---|
| Shikilia (Vipimo) | Sample hold, peak hold, bottom hold, peak-to-peak hold, average hold, delay hold |
| Bidhaa (Vipimo) | ZX-GIF11/-GIF11A |
| Nyingine (Vipimo) | Measurement cycle setting, threshold setting, hysteresis setting, initialization, key lock |
| Nyenzo (Vipimo) | Case: PBT (polybutylene terephthalate), cover: Polycarbonate |
| Kiashiria (Vipimo) | Power ON (green), controller communications (orange), controller communications error (red), RS-232C communications (orange),RS-232C communications error (red), binary output (orange) |
| Mstari (Vipimo) | ±0.1% F.S.2 |
| Muonekano (Vipimo) | Separate type |
| Azimio (Vipimo) | 10 µm (number of process values to average: 16)3 |
| Vifaa (Vipimo) | ZX-GIF_1A: Setup coftware (CD-ROM), 2 clamps, instruction sheetZX-GIF_1: 2 clamps, instruction sheet |
| Hesabu (Vipimo) | 2 possible on up to two controllers (calculation Unit ZX-CAL2 is required for connecting controllers to each other.) A-B, A+B, width |
| Aina ya matokeo (Vipimo) | NPN |
| Urefu wa kebo (Vipimo) | RS-232C 0.5 m, binary output 2 m |
| Chanzo cha mwanga (Vipimo) | Visible semiconductor laser diode (wavelength 650 nm, CLASS 1 of EN60825-1/IEC60825-1, CLASS of FDA(21CFR 1040.10 and 1040.11) |
| Matokeo ya analogi8 (Vipimo) | For current output: 4 to 20 mA/F.S., max. load resistance 300ΩFor voltage output: ±4 V, (±5 V, 1 to 5 V9), output impedance 100Ω |
| Kazi kuu (Vipimo) | Number of registeredsetups |
| Kupima upana (Vipimo) | 28 mm |
| Kazi za kipima muda (Vipimo) | ON-delay, OFF-delay, one-shot |
| (Vipimo na maelezo ya kuagiza) | Order code |
| Unyevu wa mazingira (Vipimo) | Operating and storage: 35% to 85% (with no condensation) |
| Hali ya kipimo (Vipimo) | Interrupted beam width measurement, incident beam width measurement, outer diameter measurement, center position measurement, IC lead pitch,IC lead width judgment, specified edge measurement, wire position measurement, glass edge position measurement |
| Umbali wa kuhisi (Vipimo) | 0 to 500 mm |
| DC (Vipimo na maelezo ya kuagiza) | NPN |
| Mzunguko wa kipimo6 (Vipimo) | 1.5 ms (standard mode (NORM))0.5 ms (high-speed mode (FAST))7 |
| Sampuli kwa wastani (Vipimo) | 1/2/4/8/16/32/64/128/256/512/1024/2048/4096 |
| Mita 1 (Vipimo na maelezo ya kuagiza) | 1 m |
| Mita 2 (Vipimo na maelezo ya kuagiza) | ZX-XGC2A |
| Mita 5 (Vipimo na maelezo ya kuagiza) | ZX-XGC5A |
| Mita 8 (Vipimo na maelezo ya kuagiza) | ZX-XGC8A |
| Halijoto ya mazingira (Vipimo) | Operating: 0 to 50°C, storage: -15 to 60°C (with no icing or condensation) |
| Lango la mawasiliano (Vipimo) | RS-232C (9-pin D-sub connector) |
| Matumizi ya sasa (Vipimo) | 150 mA max. (including receiver) |
| Nguvu ya dielektri (Vipimo) | 1,000 VAC, 50/60 Hz for 1 min |
| NPN (Vipimo na maelezo ya kuagiza) | ZX-GIF11A |
| PNP (Vipimo na maelezo ya kuagiza) | ZX-GIF41 |
| Mita 20 (Vipimo na maelezo ya kuagiza) | ZX-XGC20A |
| Kazi za marekebisho (Vipimo) | Optical axis adjust mode/light intensityt writing mode, variable binary level, variable edge filter, analog output scaling |
| Kiwango cha ulinzi (Vipimo) | IEC60529 IP20 |
| Kiashiria (kipokeaji) (Vipimo) | Optical axis setting indicator (green) |
| Viashiria (kitoaji) (Vipimo) | Laser ON indicator (green), laser alarm indicator (red) |
| Jina (Vipimo na maelezo ya kuagiza) | Order code |
| Volti ya usambazaji wa umeme (Vipimo) | Supplied from controller (power consumption: 60 mA max.) |
| Aina (Vipimo na maelezo ya kuagiza) | Optical system |
| Vitendakazi vya kuweka upya sifuri (Vipimo) | Offset setting of zero reset value, zero reset value memory |
| Kidhibiti kinachooana (Vipimo) | ZX-GTC11 |
| Upinzani wa insulation (Vipimo) | 20 MΩ(at 500 VDC megger) |
| Uzito (hali iliyojaa) (Vipimo) | ZX-GIF_1A: Approx. 550 gZX-GIF_1: Approx. 330 g |
| Kitu cha chini cha kuhisi (Vipimo) | 0.5 mm dia.1 |
| Onyesho wakati wa kipimo (Vipimo) | Measured value, resolution, threshold, voltage output value, current output value (number of display digits can be changed) |
| Ingizo la ingizo/usawazishaji la Laser (Vipimo) | ON: Short-circuited with 0 V or 1.5 V max.OFF: Open (leakage current: 0.1 mA max.) |
| Tabia ya halijoto (Vipimo) | ±0.005% F.S./°C |
| Aina ya matokeo (Vipimo na maelezo ya kuagiza) | Order code |
| Matumizi ya nguvu (kitoaji) (Vipimo) | 30 mA max. |
| Urefu wa kebo (Vipimo na maelezo ya kuagiza) | Quantity |
| Ugavi wa umeme (Vipimo na maelezo ya kuagiza) | Output type |
| Aina tofauti (Vipimo na maelezo ya kuagiza) | Through-beam |
| Volti ya usambazaji wa umeme (emitter) (Vipimo) | 24 VDC+10%, -15% ripple (p-p) 10% max. |
| Kebo ya kawaida (Vipimo na maelezo ya kuagiza) | Flexible cable |
| Aina iliyojumuishwa (Vipimo na maelezo ya kuagiza) | 40 mm |
| Kitengo cha kuhesabu (Vipimo na maelezo ya kuagiza) | ZX-CAL2 |
| Kiashiria cha kengele ya kuzorota kwa leza (Vipimo) | NPN open-collector output30 VDC 20 mA max.Residual voltage 1.2 V max. |
| Kifuatiliaji mahiri cha GT (Vipimo na maelezo ya kuagiza) | ZX-GSW11 |
| Upinzani wa mtetemo (uimara) (Vipimo) | 10 to 150 Hz single-amplitude: 0.75 mm for 80 min each in X, Y and Z directions |
| Matokeo ya binary ya biti 12 (D11 hadiD0, GATE) (Vipimo) | NPN open-collector output30 VDC 20 mA max.Residual voltage 1.2 V max. |
| Mwangaza wa mazingira unaofanya kazi (kitoaji) (Vipimo) | 3,000 lx (incandescent light) |
| Mwangaza wa mazingira unaofanya kazi (kipokezi) (Vipimo) | 1,000 lx (incandescent light)5 |
| Matokeo ya JUU/PASI/CHINI ya Hukumu10 Matokeo ya Sawazisha11 (Vipimo) | NPN open-collector output30 VDC 50 mA max.Residual voltage 1.2 V max. |
| Ingizo la muda, ingizo la kubadili benki, ingizo la kuweka upya sifuri, ingizo la kuweka upya (Vipimo) | ON: short-circuited with 0 V or 1.5 V max.OFF: Open (leakage current: 0.1 mA max.) |
Maelezo ya Bidhaa
Barrier sensor 40mm 10om Width max. 28mm PNP
Vipengele Muhimu
- Ubora wa kiwango cha viwanda
- Inaendana na RoHS
- Imethibitishwa CE
- Dhamana ya mwaka 1
Maelezo ya Kiufundi
Type
Nyaraka za Bidhaa
Jalada la data
Speci za kiufundi na data ya utendaji
Mwongozo wa Mtumiaji
Mwongozo wa usakinishaji na uendeshaji
