Kipatikana Bidhaa Maarufu
UHLAC1P
UHLAC1P HLAC1P HL-AC1P PANASONIC HL-T1 sensor controller PNP, 12-24VDC
$0.00USD
4344 kwenye hisa
Vipimo Muhimu
Bidhaa:Ultra-compact Laser Collimated Beam Sensor
Aina:PNP output
Uzito:Net weight: 140 g approx.
Maelezo:Controller (PNP output)
Taarifa za Msambazaji
PANASONIC
Bidhaa: 4316
Kwa kawaida husafirisha ndani ya siku 2-3 za kazi
Ubora Umeheshimiwa
Usafirishaji wa haraka
Msaada wa Kiufundi
Speci ya Kiufundi
| Kipengele | Thamani |
|---|---|
| Bidhaa | Ultra-compact Laser Collimated Beam Sensor |
| Aina | PNP output |
| Uzito | Net weight: 140 g approx. |
| Maelezo | Controller (PNP output) |
| Nyenzo | Enclosure: Polybutylene terephthalateTransparent cover: Polycarbonate |
| Kebo ya I/O | 0.09 mm210-core composite cable, 2 m6.562 ftlong |
| Nambari ya Sehemu | HL-AC1P |
| Weka upya ingizo | +V connection: EffectiveOpen: Ineffective-Applied voltage: 30 V DC or less (leak current: 0.1 mA or less) |
| Jina la bidhaa | Ultra-compact Laser Collimated Beam Sensor HL-T1 |
| Ingizo la muda | +V connection: EffectiveOpen: Ineffective-Applied voltage: 30 V DC or less (leak current: 0.1 mA or less) |
| Pato la mstari | Current / voltage output switchable (Note)-During current output: 4 to 20 mA/F.S., Maximum load resistance: 300 Ohm-During voltage output: plus or minus 4 V/F.S., Output impedance 100 Ohm(In the monitor focus function, it can also be set at plus or minus 5 V, 0 to 5 V, etc.)(Note) Switching between current and voltage is accomplished by a switch on the bottom of the controller. |
| Kazi kuu | ・Measured value display・Setting value, light amount value resolution display・Standard received light setting・Automatic scaling・Scaling・Display reverse・ECO display・Display digits limitation・Sample hold・Peak hold・Bottom hold・Peak to peak hold・Self peak hold・Self bottom hold・Zero reset・Initial reset・ON-delay timer・OFF-delay timer・One-shot timer・Differentiation・Sensitivity selection・Threshold value direct setting・Positioning teaching・2-point teaching・Automatic teaching・Hysteresis width variability・Monitor focus・Non-measuring time setting・(A – B) calculation(Note：The calculation unit is necessary.)・(A + B) calculation(Note：The calculation unit is necessary.)・Mutual interference prevention (Note：The calculation unit is necessary.)・Laser deterioration detection・Key lock・Zero reset memory |
| Nambari ya Bidhaa | HL-AC1P |
| Volti ya usambazaji | 12 to 24 V DC plus or minus 10 % Ripple P-P 10 % or less |
| Ingizo la KUZIMA kwa Leza | +V connection: Laser emission haltOpen: Laser emission-Applied voltage: 30 V DC or less (leak current: 0.1 mA or less) |
| Mzunguko wa kupimia | 150 micro s |
| Kiwango cha uchafuzi wa mazingira | 3 (industrial environment) |
| Ingizo la kuweka upya sifuri | +V connection: Zero reset operatesOpen: Zero reset ineffective-Applied voltage: 30 V DC or less (leak current: 0.1 mA or less) |
| Matumizi ya sasa | 190 mA or less (when connected to the sensor head) |
| Kiendelezi cha kebo ya I/O | Extension up to total 10 m32.808 ftis possible, with 0.09 mm2or more, cable.(Note) If the extension cable is longer than 10 m32.808 ft, then it will not qualify for CE marking. |
| Onyesho la chini ya dijitali | 5 digit yellow LED display[RUN mode: Either the resolution or laser beam reception amount will be displayed. THR mode: The threshold value will be displayed., Reverse mode: The display orientation will be reversed.] |
| Onyesho kuu la kidijitali | 5 digit red LED display[RUN mode: Either the measured value (mm) or the hold value will be displayed. Reverse mode: The display orientation will be reversed.] |
| Upinzani wa insulation | 20 MOhm , or more, with 500 V DC megger between all supply terminals connected together and enclosure |
| Kichwa cha kitambuzi kinachotumika | HL-T1001A/T1001F, HL-T1005A/T1005F, HL-T1010A/T1010F |
| Ustahimilivu wa volteji | 1,000 V AC for one min. between all supply terminals connected together and enclosure |
| Viashiria: Wezesha (Wezesha) | Green LED (lights up during normal operation) |
| Viashiria: Matokeo ya hukumu | HIGH: Orange LED (lights up when measured value > HIGH threshold value)PASS: Green LED (lights up when HIGH threshold value >= measured value >= LOW threshold value)LOW: Yellow LED (lights up when LOW threshold value > measured value) |
| Viashiria: Kuweka upya sifuri (SIFURI) | Green LED (lights up when the zero reset function is enabled) |
| Kiwango cha wastani cha sampuli kinachoweza kutatuliwa | 1 / 2 / 4 / 8 / 16 / 32 / 64 / 128 / 256 / 512 / 1,024 / 2,048 / 4,096(Note) The judgment output and linear output and linear output response time is calculated by (Measuring cycle) x (Set average sampling rate + 1). |
| Utii wa maagizo ya kuashiria CE | EMC Directive, RoHS Directive |
| Matokeo ya hukumu (JUU, JUU, CHINI) | PNP open-collector transistor-Maximum source current: 50 mA-Applied voltage: 30 V DC or less (between judgment output and +V)-Residual voltage: 2 V or less (at 50 mA source current) |
| Viashiria: Utoaji wa leza (LD ON) | Green LED (lights up during laser emission) |
| Upinzani wa mazingira: Unyevu wa mazingira | 35 to 85 % RH, Storage: 35 to 85 % RH |
| Upinzani wa mazingira: Upinzani wa mshtuko | 300 m/s2acceleration (30 G approx.) in X, Y and Z directions three times each |
| Pato la mstari: Sifa za halijoto | plus or minus 0.2 % F.S./℃(Note) These are the temperature characteristics of the linear output when the sensor head is connected. |
| Upinzani wa mazingira: Joto la kawaida | 0 to +50 ℃+32 to +122 ℉(No dew condensation allowed), Storage: -25 to +65 ℃-13 to +149 ℉ |
| Upinzani wa mazingira: Upinzani wa mtetemo | 10 to 150 Hz frequency, 0.7 mm0.028 indouble amplitude in X, Y and Z directions for 80 min. |
| Matokeo ya hukumu (JUU, JUU, CHINI): Uendeshaji wa matokeo | HIGH: ON when measured value > HIGH threshold valuePASS: ON when HIGH threshold value >= measured value >= LOW threshold valueLOW: ON when LOW threshold value > measured value |
| Matokeo ya hukumu (JUU, JUU, CHINI): Idadi ya matokeo | HIGH / PASS / LOW 3 values output |
| Matokeo ya hukumu (JUU, JUU, CHINI): Kategoria ya matumizi | DC-12 or DC-13 |
| Matokeo ya hukumu (JUU, JUU, CHINI): Ulinzi wa mzunguko mfupi | Incorporated |
Maelezo ya Bidhaa
HLT1 series controller, 12-24 VDC power, PNP digital output, selectable analog output between 4-20mA and ±4V
Vipengele Muhimu
- Ubora wa kiwango cha viwanda
- Inaendana na RoHS
- Imethibitishwa CE
- Dhamana ya mwaka 1
Nyaraka za Bidhaa
Jalada la data
Speci za kiufundi na data ya utendaji
Mwongozo wa Mtumiaji
Mwongozo wa usakinishaji na uendeshaji
