BDF-WLS3

Remote ControlBDF-WLS3smart-house transmitter for building automation applications3 individually programmable push-buttons3 V battery supply (CR2032)Channel programming using BGP-COD-BAT Range up to 40 m in open airBattery life: up to 5 years at normal useINPUT SPECIFICATIONSWireless push-buttonTransmission frequency868 MHzSUPPLY SPECIFICATIONSPower supplyBattery: CR2032 3VGENERAL SPECIFICATIONSChannel codingVia BGP-COD-BAT and special cable: GAP-TPH-CAB.Following the installation, the program- ming can be changed by removing the thin cover between the push-buttons and using the supplied adapter for the GAP-TPH-CAB cable.Battery change It is possible to change battery if thebattery voltage is low. Use a sharp object to separate the two plastic parts. Replace the battery and reassemble the plastic parts by pressing them together.Out 1-3Push-button 1-3HousingCompactEnvironmentProtection degree IP 20Pollution degree 3 (IEC 60664) Operating temperature 0-50°C/32-122°F Storage temperature -20-70°C/-4-158°FHumidity(non-condensing)20 - 80%Weight30 g – battery includedMODE OF OPERATIONThe BDF-WLS3 remote control is designed for base unit BH4-WBUx-230 and will only function with this unit.The remote control is programmed using aBGP-COD-BAT (see data sheet for this unit).The communication between BDF- WLS3 and the BH4-WBUx-230 base is established in the following way:- Push the “Mode” button on the BH4-WBUx-230 base until the red LED indicates association.- Push the push-button on the BDF- WLS3 remote control module that youwanttoassociatewiththe BH4-WBUx-230 base.Once the association is complete, the LED will light up briefly (approx. 1 second).If the association fails, e.g. because the range is exceeded, the LED in the remote control module will light up simultaneously for approx.500 ms. This also occurs if, under normal circumstances, it is not possibletoestablishconnectionbetween the BH4-WBUx-230 base and the BDF-WLS3 remote control modules.It is possible to disable the commu- nication between the BH4-WBUx-230 base and all the modules with which it is associated.- Push the “Mode” button on the BH4-WBUx-230 base until the red “Disable” LED is lit.This means that there is no connec- tion between the BH4-WBUx-230 base and its associations.To reestablish the connection, push“Mode” until neither “Associate” or“Deactivate” are lit.Under normal circumstances, the“Supply” and “smart-house” LEDswillbelitcontinuously,whereasthe LED for “Communication” onlyblinks briefly when you push anassociated BDF-WLS3 remote con-trol.The LED always lights up when youpush a button.The LED indication provides confir-mation that the communication issuccessful.DIMENSIONS (mm)1245TYPE SELECTIONSupply Ordering noBattery BDF-WLS32 3 COMMUNICATION EXAMPLE1smart-house bus2 31PUSH BOTTON/LED ALLOCATION1 2BH8-CTRLZx-xxx1 2BH4-WBUA-2302 31LEDIO1 Pushbutton 1IO2 Pushbutton 2IO3 Pushbutton 3IO5 LED IO6 LED IO7 LEDPowersmart-houseRF Associate DisableModeSpecifications are subject to change without notice (07.11.2007) - A product of the CARLO GAVAZZI Group